This double cardan style CV drive shaft is necessary for Jeep JK models equipped with 3.5-6-inch short arm suspension lifts or 2.5-6-inch long arm suspension lifts. It features a replacement flange for the differential pinions as opposed to using an adapter flange. These flanges are machined from solid billet steel. Tom Woods designed this to accept standard “off the shelf” mating flanges. If these flanges ever break, you at least stand a chance of getting a replacement part from almost any drive line shop. This also nets a longer drive shaft with the center of the universal joint closer to the pinion bearing.
Rough Country’s CV Front Drive Shaft for SA 3.5-6-inch or LA 2.5-6-inch Lifts – 5071.1A
$399.95
Jeep: 12-18 Wrangler JK 4WD, 12-18 Wrangler Unlimited JK 4WD, 07-11 Wrangler JK 4WD (Dana 30 Front), 07-11 Wrangler Unlimited JK 4WD (Dana 30 Front)
Extended CV drive shaft, flanges/yokes, and hardware
For 12-18 Fits Dana 30 and Dana 44 front axles only, For 07-11 Fits Dana 30 front axles only; Recommended on models with 3.5-6-inches of short arm lift or 2.5-6-inches of long arm lift
CVO Rear Driveshaft. Rubicon Express drive shafts and components are as good as they get. Atlas transfer cases and any other 1310 series CV yoke. Measurements are taken center to center on the u-joint with the slip stub at the center of its travel. Measure your vehicle on the ground in the running position to get correct length.
Details:
TJ CVF Rear Drive Shaft. Spicer drive shafts and components are as good as they get. This drive shaft is compatible with the RE1807, RE1801 Slip yoke eliminator kits and Currie Enterprises tail shaft conversion kits. Measurements are taken from flange face to center of the rear u-joint with the slip stub at the center of its travel. measure your vehicle on the ground in the running position to get correct length.
Details:
CVO Rear Driveshaft. Rubicon Express drive shafts and components are as good as they get. Atlas transfer cases and any other 1310 series CV yoke. Measurements are taken center to center on the u-joint with the slip stub at the center of its travel. Measure your vehicle on the ground in the running position to get correct length.
Details:
TJ CVF Rear Drive Shaft. Spicer drive shafts and components are as good as they get. This drive shaft is compatible with the RE1807, RE1801 Slip yoke eliminator kits and Currie Enterprises tail shaft conversion kits. Measurements are taken from flange face to center of the rear u-joint with the slip stub at the center of its travel. measure your vehicle on the ground in the running position to get correct length.
Details:
TJ CVF Rear Drive Shaft. Spicer drive shafts and components are as good as they get. This drive shaft is compatible with the RE1807, RE1801 Slip yoke eliminator kits and Currie Enterprises tail shaft conversion kits. Measurements are taken from flange face to center of the rear u-joint with the slip stub at the center of its travel. measure your vehicle on the ground in the running position to get correct length.
Details:
