Dana 44 Inner Axle Shaft 30 Spl LH Side 07-Pres Wrangler JK Rubicon G2 Axle and Gear 97-2051-002

G2 high strength axle shafts are engineered to withstand the added load of high torque applications and to remedy the common faults found with factory shafts. Forged from high grade alloy steel and heat treated to exceed OEM specifications, these axles are designed for extended service life. Added features such as Big Spline options, rolled splines and use of better materials allow you to confidently run larger tires without the risk of failure.
Details:

• G2 Axle and Gear Dana 44 JK Rubicon Replacement Axle Shaft
• 32 Spline
• 31.18in. Overall Length
• 5 on 5in. Bolt Circle
• 1/2in. Thread in Wheel Studs Not Included
• 2.828in. Pilot
• For Use On 2007 and up Jeep Wrangler JK Rubicon Only Driver Side
• Wheel Studs Not Included

G2 Rear Axle Kits are made from high tensile alloy steels. These axles are forged and heat-treated for maximum strength. Big Spline options allow you to take advantage of even more added strength, gained from the larger diameter of the shafts. The larger diameter enables the shafts to withstand much higher torsional loads than the stock diameter. With either option, you can be assured that the weakest point of your driveline will not be your axle shafts.
Details:

• Jeep Rear Axle Kit
• Dana 44 JK Non Rubicon
• 30 Spline
• 5-Lug Dual Drilled 5 x 5 and 5 x 5.5
• For Use With 30 Spline Differential
• For Use In 2007-2014 Jeep JK Non Rubicon
• Includes:wheel bearings,seals and screw in wheel studs

G2 offers a full line of high strength 4340 chrome/nickel (Chromoly) axles designed to handle the punishment of off-road driving, increased loads of oversized tires and the high torque produced by the ultra low geared vehicles. These axles are forged from high tensile strength 4340 alloy with particular attention paid to key weak areas of the original design. Additional material is added to the yoke area surrounding the u-joint cap to prevent distortion leading to damaged bearings.
Details:

• Front Axle Kit
• Dana 30
• 27 Spline
• Machined For Full Circle Snap Rings
• Uses 5-760X Joint
• For Use In 2007-2009 Jeep Wrangler JK Non Rubicon