Dana 44 Replacement Axle Shaft RH 32 Spl 07-09 Wrangler JK G2 Axle and Gear 95-2052-2-322

G2 offers a full line of high strength 4340 chrome/nickel, or Chromoly, axles designed to handle the punishment of off-road driving, increased loads of oversized tires, and the high torque produced by the ultra low-geared vehicles. These axles are forged from high tensile strength 4340 alloy with particular attention to key weak areas of the original design. Additional material is added to the yoke area surrounding the U-joint cap to prevent distortion, which can lead to damaged bearings. Plus, the axles are machined to accept full circle clips as an added measure to prevent the loss of bearing caps. G2 axles also have a dual heat treat process that allows optimal torsional flex while simultaneously adding strength to the yoke area that is prone to distortion. The axle kits come with the u-joint already pressed in for easy assembly.
Details:

• Fits 2007 to 2016 Wrangler, Rubicon and Unlimited
• 2 and 4-door models
• 4340 Chromoly axles
• 30 spline
• Dual heat treated process for strength
• Dana 44
• Spicer U-joint pressed into axles
• Full circle clips
• Rolled spline shafts

G2 high strength axle shafts are engineered to withstand the added load of high torque applications and to remedy the common faults found with factory shafts. Forged from high grade alloy steel and heat treated to exceed OEM specifications, these axles are designed for extended service life. Added features such as Big Spline options, rolled splines and use of better materials allow you to confidently run larger tires without the risk of failure.
Details:

• G2 Axle and Gear Dana 44 JK Rubicon Replacement Axle Shaft
• 32 Spline
• 31.18in. Overall Length
• 5 on 5in. Bolt Circle
• 1/2in. Thread in Wheel Studs Not Included
• 2.828in. Pilot
• For Use On 2007 and up Jeep Wrangler JK Rubicon Only Driver Side
• Wheel Studs Not Included

G2 high strength axle shafts are engineered to withstand the added load of high torque applications and to remedy the common faults found with factory shafts. Forged from high grade alloy steel and heat treated to exceed OEM specifications, these axles are designed for extended service life. Added features such as Big Spline options, rolled splines and use of better materials allow you to confidently run larger tires without the risk of failure.
Details:

• G2 Axle and Gear Chromoly Inner Axle Shaft
• Dana 30
• 27 Spline
• 18.80in.Overall Length
• Accepts 5-7166X U-Joint
• Driver Side
• Machined to Accept Full Circle Clips
• For use in 2007-2009 Jeep JK Front Dana 30 Non Rubicon Driver Side